Residential & Commercial Irrigation
Residential & Commercial Irrigation
Before wiring your Rain-Clik, it is important to select an appropriate mounting location for the transmitter. Click here to view mounting instructions for the Rain-Click transmitter . Once the Rain-Clik is mounted, run the wire to the controller, and …
Wiring to Hunter Controllers Remove the sensor jumper across the two SEN terminals in the controller. Attach the two yellow wires to the 24 VAC terminals. Attach the blue wire to one SEN terminal and the white wire to the other SEN or SEN COM terminal. …
… The wired Hunter Rain-Clik can be ran up to 200 feet from the controller. Once the Rain-Clik is mounted, run the wire to the controller, and fasten it every few feet with wire clips or staples for best results. View the wired Rain-Clik installation …
Before choosing a location to mount the Rain-Clik transmitter, keep these tips in mind. Choose a location such as the side of a building or post. Do not exceed 800 ft (275 m) for the wireless model. The closer the transmitter is to the receiver, the …
The Rain-Clik can keep the irrigation system from starting or continuing after rainfall. The time that it takes the Rain-Clik to reset for normal sprinkler operation after the rain has stopped is determined by weather conditions (wind, sunlight, humidity, …
Radio Antenna – Transmits a wireless signal to the receiver up to 800 ft. (275m). It is recommended that the antenna be oriented vertically Vent Ring – Used to adjust the reset rate or dry out time for the sensors. Opening the vents will decrease the …
Each wireless transmitter is produced with a unique address. A receiver must learn this address to work with that transmitter. This step is only necessary if transmitters and receivers are purchased separately. Note: Units purchased as a kit will already …
The battery in the Wireless Rain-Clik™ Transmitter is designed to operate for the life of the sensor by providing a sealed, maintenance-free design. The transmitter is available as a replacement part (WRCLIK-TR). Should you need to change the transmitter, …
On the other hand, the Rain-Clik has the Quick Response feature that commands a controller to shut off immediately right when it starts to rain so no rainfall has to be accumulated before the switch is activated and interrupts the circuit from the …
Your Hydrawise controller can connect to the internet via your Wi-Fi router and is then available for you to use through your smart devices (phone, tablet) and your computer. The following Wi-Fi requirements apply to your Hunter Hydrawise-ready …