Residential & Commercial Irrigation
Residential & Commercial Irrigation
NOTE: Do not loop the two-wire path back to the controller Two Two-Wire Paths Single Two-Wire Path DUAL-S SURGE SUPPRESSION Decoder Controller Single Two-Wire Path With T-Splices ID1 : up to 5000ft/ 1500 m from controller to each end of wire paths. …
Controller power must be OFF when installing decoders in the two-wire path. Note: Decoder wire runs and connections must be completely waterproof. Decoder wiring is more critical than "conventional" 24 VAC solenoid wiring. Follow instructions closely! …
Fault Messages Faults: Controller display shows “Fault”. This may be followed by a station number. The Station Status light on the ICore System Status dashboard will also show a red LED when there has been a decoder fault. Note: Fault light and message …
It is recommended that each decoder be programmed with station address(es) at the controller before installing it in the two-wire path. Decoders can also be programmed in the field with the Hunter ICD-HP Handheld Programmer, if available. Program the …
This instrument can operate and program ICD and DUAL decoders via wireless induction, through the base of the decoder with a programming cup. This allows access to installed decoders, without removing waterproof wire connectors. ICD-HP can also be …
Wire and wire installation is a key factor in successful decoder installations. Substitution of recommended wire and wire splices is at the installer’s own risk and is a major cause of start-up service troubles. Hunter provides two types of wire for use …
The ICD-HP Handheld Programmer is an innovative setup, programming, and diagnostic tool for Hunter ICD and DUAL series decoder products. The ICD-HP may be flash updated to the latest version, with a free download from the product Resources page. Version …