Residential Rotor - Adjustment Instructions

Identify Top Adjustments

Increase the Arc

Adjustable heads are preset to approximately 180 degrees. The PGP-ADJ is adjustable from 40-360 degrees. The PGP Ultra is adjustable from 50-360 degrees. Sprinklers may be adjusted with water on or off. It is recommended that initial adjustments be made before installation.

  1. Insert the plastic key end of the Hunter wrench into the adjustment socket .
  2. While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360° turn of the wrench will increase the arc 90°.
  3. Adjust to any arc between 40° and 360°.
  4. The wrench will stop turning, or there will be a ratcheting noise, when the maximum arc of 360° (full circle) has been reached.
Decrease the Arc
  1. Insert the plastic key end of the Hunter wrench into the adjustment socket
  2. While holding the nozzle turret at the right stop, turn the wrench counterclockwise. Each full 360° turn of the wrench will decrease the arc 90°.
  3. Adjust to any arc between 40° and 360°. The PGP Ultra is adjustable from 5-360 degrees.
  4. The wrench will stop turning, or there will be a ratcheting noise, when the minimum arc of 40° has been reached.
Radius / Distance of Throw
  1. Insert the steel hex end of the Hunter wrench into the radius adjustment (retention) screw.
  2. Turn the screw clockwise (into the stream of water) to decrease the radius, or counterclockwise to increase the radius. Radius can be reduced by up to 25%. 

Caution: Turning the radius adjustment (retention) screw clockwise more than five full turns may result in a lost radius adjustment screw. Contact the local dealer for a replacement screw if needed. Learn More

RotorRadius Screw P/N
PGP-ADJ120300SP
PGP-Ultra180900
PGJ537900
Flo-Stop Feature (I-20 Models Only)

The I-20 has a Flo-Stop control where the flow can be shut off at the rotor. The Flo-Stop is the hole in the center of rubber cover. When the I-20 is operating, insert the Hunter adjustment tool and turn clockwise until water flow stops.

Obtaining a Hunter Wrench

The Hunter adjustment wrench consists of a 3/32 Allen key, two convenient finger loops for gripping, and an opposite side arc adjustment key for all your Hunter rotor adjustments. The Hunter wrench can be purchased from your local distributor. You can also use a 3/32 Allen key for radius adjustment only.

Click here to find a distributor to purchase a Hunter Adjustment Wrench.

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support