Choose from the links below for troubleshooting your NODE battery controller.
No Display
Cause:
- Display goes off due to hibernation mode to save on battery life
- Battery is dead
Solution
- Press any button for 1 second
- Replace the battery
Shows Running, No Watering
Cause:
- No water pressure
- Faulty solenoid
- Incompatible solenoid.
- Wiring issue
Solution:
- Turn on main system supply
- Replace solenoid
- Must use Hunter DC Latching Solenoid (P/N 458200) or other compatible DC latching solenoid. Locate a dealer here if necessary. Other compatible solenoids listed in this support section.
- Wiring may be backwards. Boack should always lead to the common terminal and red to the station terminal.
Automatic Program Not Starting
Cause:
- Controller in System Off mode
- AM/PM of time of day not set correctly
- AM/PM of start time not set correctly
Solution:
- Verify that controller is programmed for automatic watering
- Correct AM/PM of time of day
- Correct AM/PM of start time
Rain sensor does not suspend watering
Cause:
- Rain sensor defective or miswired
Solution:
- Verify proper operation of the rain sensor and wire connections
- Make sure yellow was split in half and wired correctly.
Station Repeats
Cause:
- The program has more than 1 start time assigned to it
- Each program has up to 4 start times
Solution:
- Eliminate program start times as needed. For more infomation on this topic, visit support section here.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.