Residential & Commercial Irrigation
Residential & Commercial Irrigation
SiteOne Landscape Supply …
SiteOne Landscape Supply …
Central Irrigation Supply …
SiteOne Landscape Supply …
Aberiego Las Condes Design …
The ACC Controller family is available in two-wire decoder configurations. It is also possible to convert a conventional ACC family controller to two-wire decoder operation, by removing the conventional output modules and inserting the ADM-99 Decoder …
Wire, and wire installation, is a key factor in successful decoder installations. Substitution of wire and wire splices is at the installer’s own risk and is the major cause of start-up service troubles. Hunter provides various wire models for use with …
Imperial Sprinkler Supply Inc …
It is permissible to T-splice decoder wire paths All T-splices must be made in valve boxes with DBRY-6 or equal connectors T-splices consist of making a three way connection in the red wire, and a three way connection in the blue wire It is especially …
Earth Grounding of decoder systems is another part of installation that requires planning and careful installation. Properly grounded decoder systems perform very well even in regions with frequent lightning storms. Poor grounding often results in …
Two valves per output From the decoder outputs to the individual solenoids, use standard irrigation wire sized for the length of the run. Wiring from the decoder to the solenoid should not exceed 150 ft/45 m. If decoder-to-solenoid distance is over 20 …
The individual decoder station outputs are designed to operate standard 24 VAC irrigation solenoids. While solenoids vary, inrush current is normally around 0.250 Amps AC on a Hunter solenoid, with a holding current of around 0.200 Amps AC. Solenoids from …
1. P/MV terminals 2. P/MV decoders P/MV outputs may connect to the controller, or designated decoders in the two-wire path. Part of the tremendous flexibility of ACC Decoder systems is the ability to designate decoders on the two-wire path as Pump/Master …
The ICD-SEN Sensor Decoder is a special type of decoder module designed to accept inputs (from sensors), rather than outputs to stations. Each ICD-SEN has 2 sensor ports, which can report sensor status back up the two-wire path to the ACC controller. …
ICR remotes manufactured in or after September, 2006, will have 99-station capacity to operate all possible decoder stations. Set Mode to 240 max station size. NOTE: Setting station max to 240 will prevent the ICR from operating some other Hunter …
All decoder versions of the ACC controller accept the full range of Com modules for use as field controllers in central systems. ACC Decoder controllers may be mixed with other ACC controllers in any proportion in Hunter central systems, even on the same …
Download Decoder Spec General Cable layout and design is relatively simple for an ACC decoder system. The general rule is to run the two-wire paths in the pipe trenches, so that they pass near each valve location. In special circumstances, or if cable …
Wire Path Length Formula L w = 2 x V d x 1,000 R w x I w L w = Wire path length in feet or meters (1 pair wires) V d = Allowed voltage drop I w = Maximum operation current on wire path R w = Wire path resistance in ohm/1,000 ft or ohm/km V d (Voltage …
The general idea of a decoder system is to have one decoder for each solenoid (valve or head) and to have it close to the solenoid. This gives maximum irrigation control, minimum wiring, easy installation and simple documentation. When multiple solenoids …