Remove the sensor jumper across the two SEN terminals in the controller. Attach the two yellow wires to the 24 VAC terminals. Attach the blue wire to one SEN terminal and the white wire to the other SEN or SEN COM terminal. … Wiring the Receiver to Other …

The correct placement of the Freeze-Clik is critical for accurate temperature sensing. It must be mounted out of direct sunlight, and where free outdoor air circulation is possible. Examples would be the north wall of a building or under eaves and …

Note: Both the standard Freeze-Clik and the Freeze-Clik-Rev (a “reverse” model where instead of switching system operation “off” at a set temperature point, the system is switched “on”) are installed and wired in the same manner. The correct placement of …

Wiring to the X-Core Controller The Freeze-Clik connects directly to the X-Core or XC. This allows you to easily override the sensor by using the Sensor switch on the front panel. Remove the jumper from the two “SEN” terminals. Route the wires from the …

All current Hunter controllers are equipped with a built-in bypass that allows you to override an active sensor. For controllers not equipped with this feature, should you desire to bypass the operation of the Freeze-Clik for any reason (i.e., turn on …