Residential & Commercial Irrigation
Residential & Commercial Irrigation
NOTE: Connecting the Pump Start Relay should only be done by a licensed electrician following local codes. Improper installation could result in shock or fire hazard. 1) Find a suitable location to mount the Pump Start Relay. It is recommended that the …
I-Core - Front Panel Replacement …
The X-Core Controller is programmed with Solar Sync technology and, therefore, does not require the use of the Solar Sync module. Installing the Wireless Solar Sync Sensor Simply mount the Wireless Receiver on the controller cabinet using an available …
The ACC Controller is programmed with Solar Sync technology and, therefore, does not require the use of the Solar Sync module. Installing the Wireless Solar Sync Sensor Simply mount the Wireless Receiver using the supplied brackets to mount the Wireless …
The Wireless Solar Sync Receiver and Sensor are already paired with the same frequency for an easy installation. When installed, the wireless Receiver will automatically go into a “search” mode looking for the signal from its paired Sensor. However, it is …
The.Solar Sync is a sensor system that, when connected to a compatible Hunter controller, will automatically adjust your controller watering run times based upon changes in local climate conditions.The Solar Sync utilizes a solar and temperature sensor to …
The Solar Sync sensor is simple and easy to install and is compatible with all current Hunter AC powered controllers. The sensor should be placed in an area where it can receive full sun and rain; The Solar Sync sensor measures solar radiation and …
The Pro-C / PCC controller (with SOLAR SYNC position on dial) is programmed with the Solar Sync technology and, therefore, does not require the use of the Solar Sync module. The Solar Sync Sensor (SOLARSYNCSEN or WSSSEN) is wired directly to the “SEN” …
The I-Core now has the Solar Sync software built into the controller. New I-Core controllers with built in Solar Sync are easily identified by the new Solar Sync Settings dial position on the facepack. Because the new I-Core has built in Solar Sync …
After Solar Sync has been installed and programmed, we recommend allowing the system to run for a few days at the initial setting. Because of the variety in site conditions (including sensor location, amount of direct sunlight available to the sensor, …
For controllers with the Solar Sync Module installed, the Region and Water Adjustment is made on the Solar Sync Module. … For accurate measurements, the Solar Sync module needs to be programmed for the typical ET (average July ET) for your region. Press …
Connecting to the ICC The Hunter ICC controllers require the installation of the Solar Sync module as well as the Sensor. Installing the Solar Sync Module Turn off AC power to the controller before connecting the Solar Sync module to the controller. …
Use the CONTROLLER OFF feature to stop manual/automatic watering commands, set programmable days off (1-180 days), and set the controller off. Sign in to your C ENTRALUS ACCOUNT . Select a controller name from your CONTROLLER LIST . Click on the …
X-Core Selecting Specific Days of the Week to Water …
The Hunter Adjustable Arc nozzles come from the factory with a preset arc of 25 degrees. Prior to setting the left side arc, set the right side arc by ratcheting the riser assembly and aligning the right side of the spray pattern. There is no indicator …
Hunter spray bodies come preinstalled with a directional flush cap to flush debris out of the line after initial installation or service. Point flush caps at plant area, and then flush lines by running the irrigation system Using ring, raise riser to …