Residential & Commercial Irrigation
Residential & Commercial Irrigation
The Hunter Flow-Sync allows flow-capable controllers, such as the Hunter ACC and I-Core, to monitor actual flow in irrigation systems. With proper setup at the controller, this allows the controller to record and report actual flow in liters or gallons. …
Flow sensors can potentially be damaged by winterization blow-out techniques, and should be removed prior to injecting compressed air into the pipes. Hunter Flow Sync and Flow-Clik sensors are installed in FCT tee fittings. The flow sensor itself includes …
The Flow-Sync Sensor is designed to be installed within an FCT tee fitting, sized for the pipe in which it will be installed. Optional slip-BSP adapters are available separately for sizes up to 75 mm for international applications. Install the FCT tee …
The FCT tee fitting comes with a plug that allows for installation of the FCT into the irrigation system prior to installing the Sensor. This allows the FCT tee to be installed separately from the sensor and prevents damage to the sensor during …
The Hunter Flow Sensor body (FCT or Flow Clik Tee) is designed in diameters from 1" to 4"(2.54-10.16cm). It is installed into the mainline of the irrigation system, near the point of connection. It is important to install the Sensor Assembly (FCT + HFS) …
WARNING! Flow-Sync is only designed for low-voltage connection to approved irrigation controller flow terminals. do not install in high-voltage 110V or 230V circuits. Flow-Sync has two wire leads for the controller connection. These may be extended up to …
Operating Specifications Temperature Pressures Humidity 0 to 140ºF/60ºC up to 200 psi/13.7 bar up to 100% Flow Range Flow-Sync Sensor Diameter Operating Range (Gpm) Minimum* Suggested Maximum** 1" 2 17 1½" 5 35 2" 10 55 3" 28 120 4" 34 195 * Minimum …
Flow-Sync is typically installed near the point of connection, in an appropriately-sized FCT Tee. Flow-Sync can connect to the host controller via two direct burial-rated 18 AWG/1 mm wires up to 1000 ft/300 m away from the controller. Flow-Sync can also …
Cause Water shut off Controller not configured Faulty Wiring- Use voltmeter to verify red and black wires are connected, and have not been reversed. Damaged sensor- Impeller damage (debris in water) or Flow-Sync electronics damage (lightning) Solution …