Connecting a SRR or ICR Remote Control (Not Included)

The Hunter SRC is remote-ready for use with the SRR or ICR remote control system. The remote makes it possible for contractors and end-users alike to operate an system without having to walk back and forth to the controller.

To utilize the SRR or ICR Remote Control System you must install the SmartPort® outlet.

1. Install a " female threaded PVC “Tee” in the field wiring conduit (PVC pipe) approximately 12" below the SRC.
2. Feed the red, white, and blue wires of the harness through the base of the “Tee” and into the wiring compartment as shown in Figure 1.
3. Screw the harness housing into the “Tee” as shown in Figure 1.
4. Access the terminal strip area and attach the red wire to the left AC screw slot, attach the white wire to the next AC screw slot and attach the blue wire to the screw slot marked “R”.

The wiring harness is now ready for remote control use. Please refer to the SRR or ICR owner manual for further information or contact your local Hunter distributor for ordering information.

NOTE: Any extension of the wiring on the remote harness may result in an error message in the controller display and possible malfunction of the remote unit due to radio interference. In some situations, lengthening of the harness may work fine, in others it may not work at all (it is site specific). In either case, extending the wiring harness should be done using shielded cable to minimize the possible effects of electrical noise. For easiest installation, order a new Hunter SRR-SCWH SmartPort® wiring harness with a full 25 feet of shielded cable.