Mounting the Outdoor Controller to Wall

NOTE: Outdoor model is water and weather resistant. Connecting the outdoor EC to the primary power should only be done by a licensed electrician following all local codes. Improper installation could result in shock or fire hazard.

1. Select a location that is conveniently close to a power supply.
2. Make sure to abide by all electrical and installation codes when attaching to an external wall.
3. Place the controller at eye level and align keyhole (A) on top of the controller and mark the spot as well as the three holes (B) on the bottom of the unit.
4. Drill a 6 mm hole at each mark.
5. Install screw anchors (C) into holes if attaching controller to drywall, masonry, or plaster walls.
6. Holding the controller cabinet, line up the holes in the cabinet with the wall anchors or pilot holes.
7. Drive a screw through each hole and secure snugly but do not over tighten.